Home / Weed identification / Eurasian Watermilfoil
US weed ID · Aquatic weed
Eurasian Watermilfoil
Myriophyllum spicatum · Haloragaceae (water milfoil family)
- Perennial
- Submersed aquatic
- Non-native
If your lake has thick underwater beds of soft, feathery stems with reddish tips that mat at the surface in summer, you may be looking at Eurasian watermilfoil.
How to get rid of itAll weeds A–Z
What is Eurasian watermilfoil?
Eurasian watermilfoil is a rooted underwater plant from Europe, Asia and northern Africa that has spread to nearly every state, largely by hitching rides on boats and trailers. Accurate Eurasian watermilfoil identification matters because several native milfoils look almost the same, and the main test is simply counting the leaflet pairs on a leaf.
Where it thrives, it grows up through the water into dense surface mats that block light to native plants, get in the way of swimming and boating, and crowd out more diverse plant beds. Thick monocultures give fish and invertebrates poorer habitat than the native plants they replace. Not every lake suffers, though: Wisconsin surveys found most lakes there hold only low, scattered populations.
Eurasian Watermilfoil identification: what to look for
Pull a stem, float a leaf in a dish of water and count the paired leaflets on each side of its center stalk. Also note how far apart the whorls are and whether the leaves stay stiff or collapse when lifted out. Stem color varies too much to rely on by itself.
- Leaves: Feathery and arranged in whorls of four around the stem, each with 12 to 21 pairs of fine leaflets. Native milfoils usually have 10 pairs or fewer.
- Whorl spacing: Half an inch or more between whorls, giving the stem an open, airy look.
- Feel: Leaves collapse and go limp when lifted from the water, while native milfoils stay stiffer.
- Stems: Light brown, pink, green or white, often reddish toward the tips; color alone is not a safe ID.
- Flowers: A small pink spike up to 4 inches tall pokes above the surface carrying tiny yellow flowers, typically in summer.
- Roots: Fine white roots anchor the plant and survive winter after the top dies back.


Where it grows in the United States
Eurasian watermilfoil now grows in every state except Wyoming and Hawaii, and it is also established in Alaska. It was first reported in the eastern US over a century ago, reached Wisconsin in the 1960s and was first recorded in Minnesota, in Lake Minnetonka, in 1987. Its range stretches from the lakes of the Upper Midwest to Washington, where it is a listed noxious weed, and south to Mississippi.
It roots in water up to about 20 feet deep and does well in many types of lakes. New infestations usually begin with a single fragment carried in from another lake on a boat, trailer or piece of equipment, which is why public launches are common starting points.
Eurasian Watermilfoil look-alikes
A few plants get mixed up with it:
- Northern watermilfoil (Myriophyllum sibiricum): Native. It has only 5 to 9 leaflet pairs, whorls set closer together, stiffer leaves that are not usually reddish, and it forms dense, club-shaped winter buds at the stem tips late in the season.
- Hybrid watermilfoil (Myriophyllum spicatum x M. sibiricum): Eurasian and northern watermilfoil often cross. Hybrids mix traits, such as a slightly reddish stem with about 11 leaflet pairs, and may need a genetic test to confirm.
- Other native milfoils (Myriophyllum heterophyllum, M. verticillatum): Various-leaved and whorled watermilfoil also have 10 or fewer leaflet pairs and stiffer stems and leaves.
How to get rid of Eurasian watermilfoil
Pulling, digging and mowing: Hand-pulling or raking can clear a swimming area, but it breaks stems and can spread fragments, so collect every piece. Snorkelers or divers who pull plants by hand, roots and all, get longer control than raking, though it is slow work. Mechanical harvesters give short-term relief for boating but regrowth follows. Where water levels can be controlled, a winter drawdown that exposes root crowns to freezing can be very effective. In Minnesota, any mechanical removal or herbicide use in public waters needs a DNR permit.
Cultural control matters most, because the right conditions keep it from coming back.
- Clean every plant off boats, trailers, docks and gear, and drain all water before leaving the launch.
- Before entering another lake, wash equipment with high-pressure hot water or let it dry for at least five days; Minnesota requires docks, lifts and rafts to dry 21 days before moving them to another lake.
- Keep healthy native plant beds where possible, since herbicides can sometimes harm native plants more than light milfoil populations do.
- Milfoil weevils have been released in some lakes, but results have been mixed and none show reliable long-term control.
Herbicides: Systemic herbicides such as 2,4-D and triclopyr move through the plant and kill roots as well as stems, while contact products such as endothall and diquat only burn the parts they touch. Wisconsin also lists fluridone, imazamox, flumioxazin, carfentrazone-ethyl, penoxsulam and florpyrauxifen-benzyl as products used on this plant. Most treatments happen in spring during early active growth, when native plants are less exposed. Use only products labeled for aquatic sites and follow the label, which is the law. Your state may require a permit to apply herbicide to lakes; for example, Wisconsin requires an approved NR 107 permit and Minnesota requires a DNR permit for public waters. If you hire someone to spray, make sure they hold your state’s pesticide applicator license; the rules for each state are in our pesticide applicator license guide.
Keeping it from coming back
Since one fragment can start a new population, prevention comes down to boat and gear hygiene. Remove plants from hulls, motors, trailers and anchors, pull drain plugs and keep them out while traveling, put leftover bait in the trash, and dry equipment before using it in another lake. Report new finds to your state natural resources agency.
Questions we get about Eurasian watermilfoil
How do I tell Eurasian watermilfoil from native milfoil?
Count the leaflet pairs on a leaf. Eurasian watermilfoil usually has 12 or more pairs, while native milfoils have 10 or fewer. Hybrids can fall in between and may need a lab test.
Can I pull Eurasian watermilfoil myself?
You can hand-pull small patches near your dock, but collect every fragment, and check your state's rules first; Minnesota, for example, requires a permit for removal in public waters.
Why did milfoil show up in our lake?
Almost always from a fragment carried in on a boat, trailer or equipment from an infested lake.
Does Eurasian watermilfoil die in winter?
The top dies back in fall, but roots and short green shoots survive and regrow in spring.
Weeds taking over a bed, slope or wet spot?
In central Pennsylvania, Muthler rebuilds beds, regrades and drains wet ground, clears overgrown brush and builds patios and walls across Clinton, Lycoming, Centre and Union counties. Outside central PA? Groundwork Single Space ($349) is a scaled 2D plan of one area with plants matched to your hardiness zone, designed remotely.
Get a free estimateSee landscape designSimilar weeds
AlligatorweedAlternanthera philoxeroides
Common DuckweedLemna minor
Curly-Leaf PondweedPotamogeton crispusSources: Minnesota DNR: Eurasian watermilfoil · Wisconsin DNR: Eurasian watermilfoil · Mississippi State University GRI: Eurasian watermilfoil fact sheet · Washington State Noxious Weed Control Board: 2026 State Noxious Weed List · USDA PLANTS: Myriophyllum spicatum profile · USDA APHIS: Federal Noxious Weed List · USDA National Invasive Species Information Center: Eurasian watermilfoil
Herbicides: always read and follow the product label. Pesticide applicator licensing rules vary by state.